Troubleshooting inaccurate 3D calculations
You may experience unexpected calculations in your 3D layout due to specific configurations not currently supported in 3D.
If your solution includes deactivated cooling units for failure simulation, the decrease in cooling capacity is not reflected in 3D as this is currently not supported.
You can omit the airflow of a cooling unit in 3D in one of these ways:
- Change the airflow and cooling capacity of the cooling unit to 0 (by right-clicking and selecting Properties; remember to note the value first to be able to restore it after the failure simulation)
- Moving the cooling unit outside the room
- Deleting the cooling unit (not recommended unless you are working with a test setup and perform a backup first)