This checklist will help you make sure you have the necessary information to deploy the EcoStruxure IT Gateway and discover devices successfully.
Installing and setting up the EcoStruxure IT Gateway
Server or VM |
|
![]() |
Server or VM to download and install EcoStruxure IT Gateway on. |
Device IP addresses |
|
![]() |
List of IP addresses, IP address ranges, or subnets to discover devices on. |
Proxy serverThe Gateway server must use the internet to communicate with EcoStruxure IT. |
|
![]() |
No proxy server needed |
![]() |
Proxy server |
Username _______________ Password ________________ You can automatically detect the proxy server or configure settings manually. Manual settings: Proxy server address _________________ HTTP port __________________ HTTPS port __________________ |
|
Device types to discover |
|
![]() |
SNMPv1 enabled |
Read community name (public is default) ___________________________ Write community name (private is default) __________________________ Port (161 is default) __________ |
|
![]() |
SNMPv3 enabled |
Username ________________ Authentication type (MD5 or SHA) __________ Authentication password ________________ Encryption type (DES, DES3, AES128, AES192, AES256) ______________ Encryption password ________________ Port (161 is default) _____________ |
|
![]() |
NetBotz |
Username ____________________ Password _____________________ Port (80 is default, or 443 with SSL enabled) _____________ |
|
![]() |
Redfish |
Username _____________________ Password ______________________ Port (443 is default) ____________ |
|
![]() |
Modbus |
For each Modbus device to discover: Device type ___________________ Device vendor _________________ Device family __________________ Slave ID ____________ For TCP: IP address ____________________ Port (502 is default) _________ For serial: Port _________ Baud rate _________ Data bits __________ Parity __________ Stop bits __________ Flow control __________ |
|
![]() |
Advanced |
Use this option to discover these Crac devices only:
SNMPv1 enabled in device Read community name (public is default) ___________________________ Write community name (private is default) __________________________ Port (161 is default) __________ SNMPv3 enabled on device Username ________________ Authentication type (MD5 or SHA) __________ Authentication password ________________ Encryption type (DES, DES3, AES128, AES192, AES256) ______________ Encryption password ________________ Port (161 is default) _____________ |
|
Device File Transfer settings |
|
![]() |
File transfer is FTP, enabled by default. You must specify the username and password. Username _________________ Password __________________ |
Comments
0 comments
Please sign in to leave a comment.