Discover devices

Device credentials

During the initial setup of your Gateway, you specify credentials to communicate with the SNMPv1, SNMPv3, NetBotz, Redfish, or Modbus devices you want to discover. To modify these settings later, go to Settings > Device credentials.

See Installing and setting up EcoStruxure IT Gateway

Note: When AES is configured in the APC Network Management Card (NMC) interface, choose AES128 in the Gateway user interface.

Note: The EcoStruxure IT Gateway does not support SCP on APC NMC1 devices.

How to identify APC Network Management Card 1 (NMC1) devices

EcoStruxure IT Gateway versions older than 1.15 do not allow discovery of SNMPv3 devices with the Authentication type or the Encryption type set to None. 

Discover devices

To discover devices after the initial setup of your Gateway:

1. Go to Discover devices.

2. Click Configure Credentials to select specific device file transfer credentials to use in a device discovery. Otherwise, all configured credentials will be used.

   Click Manage credentials to view the credentials you have configured in the Gateway.

   To comply with stricter cybersecurity requirements across various product groups, it is recommended that you review your username/password lists in EcoStruxure IT Gateway and confirm that configured credentials are both active and accurate.

3. Specify the IP addresses or address range of the devices, or import a device list. 
   You cannot import a device list for serial Modbus discoveries.

Check out the on-screen device discovery tips.

Discovery results are displayed in the summary including discovered devices and unsupported devices that were not discovered. You can view details about unsupported devices, and see discovery results in the discovery log.

If you find that one or more of your devices is not supported, you can request device support here.

All discovered devices are listed on the Devices page.